AFX203058 Rigging Plate 8-holes

ANCHOR

Direction of Load

AFC601100

1 2

3

AFX203058

4

4

AFC601100

3

AFX206008

2

AFX202002

1

AFX203058

10. ANCHORAGE STRENGTH: Ensure that the strength of the anchorage member used is greater than 12kN.

11. LIMITATIONS:

Rigging Plates are personal property of the user. Equipment shall not be used outside its limitation, or for any purpose other than that for which it is intended. Following factors must be considered before using this product :-

Ÿ Ÿ Ÿ

Fall Clearance: There must be sufficient clearance below the anchorage connector to arrest a fall before the user strikes the ground or an obstruction. When calculating fall clearance, account for a MINIMUM 3'safety factor, deceleration distance, user height, length of lanyard/SRL, and all other applicable factors. Swing Falls: Prior to installation or use, make considerations for eliminating or minimizing all swing fall hazards. Swing falls occur when the anchor is not directly above the location where a fall occurs. Always work as close to in line with the anchor point as possible. Swing falls significantly increase the likelihood of serious injury or death in the event of a fall. Compatibility: When making connections with Rigging Plate Anchors, eliminate all possibility of roll-out. Roll-out occurs when interference between a hook and the attachment point causes the hook gate to unintentionally open and release. All connections must be selected and deemed compatible with Rigging Plate Rope Anchor s by a Competent Person. All connector gates must be self-closing and self-locking, and withstand minimum loads of 3600 lbs (16 kN). 12. REPAIR: REPAIR: If the product becomes damaged, it will NOT provide the optimum level of protection, and therefore should be immediately removed from service. It needs to be inspected to see if it is replaced or repaired. Never use the damaged product. Repair is only permitted by the manufacturer or a nominated repair centre or individual approved by the manufacturer. 13. WITHDRAWAL FROM USE : If the system has been used to arrest a fall, it should be removed from service and returned to the manufacturer or a competent repair centre for servicing and re test. Ÿ Ÿ Ÿ

14. MAINTENANCE, CLEANING, AND STORAGE: Ÿ If the Rigging Plate Anchor fails inspection in any way, immediately remove it from service. Ÿ Cleaning after use is important for maintaining the safety and longevity of Rigging Plate Anchor.

03