Honeywell North 5400,7600, RU6500 Series Instruction Manual

WARNING The NIOSH and AS/NZS approvals and all Honeywell warranties for this respirator are nullified if cartridges and/or filters from other manufacturers are used. Filters, cartridges, and filter cartridge combinations must be the same on both sides of the respirator. Only use filters, cartridges, or filter cartridge combinations for protection from contaminants listed on that filter or cartridge NIOSH or AS/NZS Approval Label. Do not use the Backpack Adapter with cartridges that have an ESLI as you will not be able to see the indicators while wearing the respirator and will not know when to change the cartridges. Failure to comply with these warnings will result in the risk of serious injury, illness, or death.

NOTE When using a full facepiece respirator in temperatures below 32°F (0°C), use an anti-fog solution (P/N 80944A) on the inside of the lens.

Figure 1

Figure 2

Figure 3

Cartridge filter

Cartridge Connector

Lens/Facepiece

Figure 4

Figure 5

PUTTING ON THE RESPIRATOR For the 5400 and 7600 Series: Follow INSPECTION directions 1 through 4, then tug once more on the cartridges or filters to assure they are securely attached. 1. Remove your hard hat or other headgear prior to putting on your respirator. 2. Adjust the head straps of the respirator to their full outward position by pulling up on the tabs to release the strap tension, then pulling the straps outward. 3. Grasp the harness by placing your hands in the harness and your thumbs between the lower straps. 4. Push the harness up on your forehead, brushing your hair upward from the seal area. (Figure 6) Continue up and over your head until the harness is centered at the rear of your head and your chin fits into the chin cup. (Figure 7) 5. Beginning with the lower straps, pull on the end tabs in small, equal increments to ensure they are tightened evenly. 6. Tighten the straps until the entire facepiece is snug, comfortable and centered on your face. (Figure 8)

7