EPIC Harness 4-Point (AFH300404)

4.

LIMITATIONS:

Harness should be the personal property of its user.

Ÿ

Ÿ The strength of the anchor device should be greater than 18 kN (for Textile) & 12kN (for Metal) and the anchor point should be situated above the user's head. It should not be used in highly acidic or basic environments. Protect the harness from mechanical hazards like sharp edges, tools, exposure to sunlight, ultraviolet degradation both during usage, transportation and storage. Use the dorsal D-Ring & front chest D-Ring for fall arrest. Lateral D-Rings for work positioning & front waist D-Ring for Rope Access. If the harness has an extension band at the back D-Ring. Make sure that the total length of the lanyard+energy absorber+ connectors+extension band is not more than 2 ms. Ÿ Ÿ Ÿ Ÿ NOTE : It is essential for the safety of the user that if the product is resold outside the original country of destination, the reseller shall provide instructions for use, for maintenance, for periodic examination and for repair in the language of the country in which the product is to be used. FREE FALL: Personal fall arrest systems used with this equipment must be rigged to limit the free fall to 4.0 M as per EN 361:2002. Restraint systems must be rigged as per EN 354:2010 so that no vertical free fall is possible. Work positioning systems as per EN 358:2018 must be rigged so that free fall is limited to 1m or less. Personnel riding systems must be rigged so that no vertical free fall is

5.

possible. Climbing systems must be rigged so that free fall is limited to 2L+1 or less. Rescue systems must be rigged so that no vertical free fall is possible. See subsystem manufacturer's instructions for more information. Below figure illustrates fall clearance requirements. There must be sufficient clearance below the user to allow the system to arrest a fall before the user strikes the ground or other obstruction. Clearance required is dependent on the following factors: l Elevation of Anchorage l Connecting Subsystem Length l Deceleration Distance l Free Fall Distance l Worker Height l Movement of Harness Attachment Element 6. SWING FALLS: D F E B A A Connecting Subsystem (Energy Absorbing Lanyard Shown) B Working Level C Lower Level or Obstruction D Free Fall 4 mts max as per EN 361:2002 E Deceleration Distance F Total Fall Distance Free Fall (D) + Deceleration (E)

C

Swing falls occur when the anchorage point is not directly above the point where a fall occurs. The force

of striking an object in a swing fall may cause serious injury or death. Minimize swing falls by working as close to the anchorage point as possible. Do not permit a swing fall if injury could occur. Swing falls will significantly increase the clearance required when a self retracting lifeline or other variable length connecting subsystem is used. 7. EXTENDED SUSPENSION: A full body harness is not intended for use in extended suspension applications. If the user is going to be suspended for an extended length of time it is recommended that some form of seat support be used. KStrong recommends an Easy seat. Contact KStrong for more information on this item.

02