AFH300703- AtexWorX Anti-Static Harness

4. FREE FALL: Personal fall arrest systems used with this equipment must be rigged to limit the free fall to 4.0 M per EN 361:2002. Restraint systems must be rigged as per EN 354:2010 so that no vertical free fall is possible. Personnel riding systems must be rigged so that no vertical free fall is possible. Climbing systems must be rigged so that free fall is limited to 2L+1 or less. Rescue systems must be rigged so that no vertical free fall is possible. See subsystem manufacturer's instructions for more information.

A

A Connecting Subsystem (Energy Absorbing Lanyard Shown) B Working Level C Lower Level or Obstruction D Free Fall 4 mts max as per EN 361:2002 E Deceleration Distance F Total Fall Distance Free Fall (D) + Deceleration (E)

D

F

B

E

C

Figure (as above) illustrates fall clearance requirements. There must be sufficient clearance below the user to allow the system to arrest a fall before the user strikes the ground or other obstruction. Clearance required is dependent on the following factors: Ÿ Elevation of Anchorage Ÿ Connecting Subsystem Length Ÿ Deceleration Distance Ÿ Free Fall Distance Ÿ Worker Height Ÿ Movement of Harness Attachment Element

5. SWING FALLS: Swing falls occur when the anchorage point is not directly above the point where a fall occurs. The force of striking an object in a swing fall may cause serious injury or death. Minimize swing falls by working as close to the anchorage point as possible. Do not permit a swing fall if injury could occur. Swing falls will significantly increase the clearance required when a self retracting lifeline or other variable length connecting subsystem is used.

6. EXTENDED SUSPENSION: A full body harness is not intended for use in extended suspension applications. If the user is going to be suspended for an extended length of time it is recommended that some form of seat support be used. KStrong recommends an Easy seat. Contact KStrong for more information on this item. 7. ENVIRONMENTAL HAZARDS: Use of this equipment in areas with environmental hazards may require additional precautions to prevent injury to the user or damage to the equipment. Hazards may include, but are not limited to heat, chemicals, corrosive environments, high voltage power lines, gases, moving machinery, and sharp edges.

02